ByN Lavanya
Last modified: A) 0.0707 m2
B) 0.0616 m2
C) 0.0524 m2
D) 0.0491 m2
As per IS 1239 (Part 1)-2004 for Pipes, the internal diameter is 300 mm or 0.3 m.
The internal radius r = (Internal diameter/2) = 0.3/2 = 0.15 m
The internal cross-sectional area A = πr2
= π x (0.15)2
= 0.0707 m2
Therefore, option A is the correct answer.
Lavanya is a passionate content writer about Structural Design, Grouting, Columns, Beams etc. She has 5 years of experience in teaching in Civil Engg. She enjoys writing complete guides and tips. Her passion is in building materials, construction standards, foundation design and building codes.
A) 2 points , at L/4 and 3L/4 from left supportB) 1 point , at L/2 from left supportC) 3 points , at L/3, L/2 and 2L/3 from left supportD) No point of contra flexure Reference:As per theory of structural analysis, in a fixed beam with a central point load, there are two points of…
A) 0B) 0.25C) 0.5D) 1 According to IS 456:2000, Clause 6.2, Poisson’s ratio is defined as the ratio of transverse strain to axial strain. For a material that does not change in volume under stress, the transverse and axial strains must be equal in magnitude but opposite in sign. Therefore, the Poisson’s ratio for such…
A) Mild steelB) Cast ironC) AluminumD) Copper Explanation: As per IS 1608, when a ductile material like mild steel is subjected to tensile test, it undergoes significant plastic deformation before failure. This causes necking at the fractured section, where the diameter reduces substantially. However, brittle materials like cast iron and aluminum do not undergo plastic…
A) 1.33 N/mm2B) 2.67 N/mm2C) 4 N/mm2D) 5.33 N/mm2 Reference:As per IS 456:2000, the shear stress formula is:τ = VQ/IbWhere,τ – Shear stressV – Shear forceQ – First moment of area above or below the neutral axisI – Moment of inertiab – Width of beam For a rectangular section, I = bd3/12Q = A x…
A) ToughnessB) Proof ResilienceC) DuctilityD) Malleability According to IS 800:2007, Clause 2, Proof resilience is defined as the maximum strain energy that a material can absorb per unit volume without any permanent deformation. This is an important design consideration as it indicates the ability of a material/component to absorb shock and impact loads by undergoing…
A) Tensile stressB) Compressive stressC) Shear stressD) No stress Explanation: As per theory of thermal stresses, when a body is restricted from free expansion or contraction, it develops internal stresses when subjected to change in temperature. If a constrained part is heated, it tends to expand. But restriction to movement causes development of compressive stresses…