Structural Design > Columns
- Effective length of an RCC compression member of unsupported length
- Unsupported length (l) of a column whose one end is unrestrained
- Total Area Of Longitudinal Bars In A Column
- Minimum And Maximum Values Of Longitudinal Reinforcements
- Short Compression Member
- Maximum Compression Strain In Concrete In Axial Compression
- Cross-Sectional Area Of Longitudinal Reinforcement
- Percentage Of Steel For Reinforced Concrete
- Longitudinal Reinforcement Of Columns
Structural Design > RCC
-
Which of the following statements correctly explains the meaning of the concrete mix ratio 1:3:6?
-
As per IS 10262:2019, the standard normal consistency for M60 grade high strength concrete having a minimum 28-day cube compressive strength of 60 MPa is:
-
As per IS 456-2000, what is the maximum free water to cement ratio of an M20 grade reinforced concrete under mild exposure conditions?
-
The maximum energy that a given component can absorb without undergoing any permanent deformation up to its elastic limit is known as:
-
If a piece of material neither expands nor contracts in volume when subjected to stress, then the Poisson’s ratio must be:
-
The internal diameter of a cast iron pipe is 300 mm and its thickness is 10 mm. If the pipe is supported at two points 8 m apart, what is the internal cross-sectional area of the pipe as per IS:1239 (Part 1)?
-
If a part is constrained to move and heated, it will develop:
-
A fixed beam of span L is subjected to a central point load P. What are the number of points of contraflexure and their respective positions from the left support?
-
A round bar specimen is subjected to a tensile test. After fracture, it is observed that the diameter at the fractured section remains approximately the same as the original diameter. What material was the round bar most likely made of?
-
A rectangular concrete beam has a width of 300 mm and a depth of 500 mm. It is subjected to a shear force of 20 kN. What is the shear stress at a depth of 150 mm from the neutral axis?
Concrete Technology
-
Which of the following statements correctly explains the meaning of the concrete mix ratio 1:3:6?
-
As per IS 10262:2019, the standard normal consistency for M60 grade high strength concrete having a minimum 28-day cube compressive strength of 60 MPa is:
-
As per IS 456-2000, what is the maximum free water to cement ratio of an M20 grade reinforced concrete under mild exposure conditions?